![]() This value takes precedence over default and compatibility configurations. The power consumption of the machine can be capped with a user-defined value between 6 watts. In this case, the power will be limited to 1500 watts. The power used by a system can be limited (capped) using a ceiling imposed by the powercap utility.ĭepending on the state of the machine, different values might take effect:īy default, the power cap is set to 1700 watts on Bow-2000, and 1500 watts on IPU-M2000.īow-2000 can be configured to be power cap compatible with IPU-M2000, if compatibility mode is enabled. To reboot the BMC, use the Linux reboot command. Turn on power for the IPU and IPU-Gateway domains Safely turn power off and on for all power domains including the connector domain Save state and turn off power for the IPU and IPU-Gateway domains Immediately turn off power for the IPU and IPU-Gateway domains, without saving state You can use the ipum-utils command to control power. This section describes power management operations using the CLI, REST, IPMI and Redfish interfaces. - negates a single word or phrase (returns results without that word or phrase).You can use the following logical operators in a search: N is the maximum number of positions allowed between matching words. Words close to each other: ~N (tilde followed by a number) after a phrase (in quotes) returns results where the words are close to each other.N specifies the “edit distance” (fuzziness) of the match. ![]() This will return results that are similar to the search word. Fuzzy search: Use ~N (tilde followed by a number) at the end of any word for a fuzzy search.This will return results containing all words with the specific prefix. Prefix query: Add an * (asterisk) at the end of any word to indicate a prefix query.For example "PyTorch for the IPU" or "replicated tensor sharding" ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |